Flash_Switch firmware install tool for the switch card CYPSWITCHMP Usage: Flash_Switch where switch_number can be 1 for switch #1 2 for switch #2 B for both switches firmware_image can be MBX12 - the switch connects to the motherboard with up to 12 drive support per switch (4 lanes per drive) MBX24 - the switch connects to the motherboard with up to 24 drive support per switch (2 lanes per drive, SRIS capable drives are required) HWRX12 - the switch connects to the RS3P4TF160F RAID controller with up to 12 drive suport per switch (4 lanes per drive) All arguments must be written in upper case ! Example: flash_switch B HWRX12 This command will flash both installed switches with the firmware which supports up to 12 drives managed by the RS3P4TF160F RAID controller. Note: If the switch card is connected to the system motherboard and the HWRX12 is installed, after DC cycling the system the switch card will not be detectable. The switch card will need to be connected to an RS3P4TF160F RAID controller to be detected again. WARNING don't flash the HWRX12 firmware version on the switch card if there is no intention to connect the switch to an RS3P4TF160F RAID controller, otherwise, the switch will no longer be detectable when connected to the motherboard. There is no way to recuperate the switch card other than connecting it to an RS3P4TF160F RAID controller and flash is back with a motherboard version.