Intel(R) LAN Driver Speed/Duplex Parameter Change Utility for Windows
Version 1.0.0.0
=====================================================================

DISCLAIMER:
-----------
Copyright (c) 2003, Intel Corporation. All rights reserved. Intel 
Corporation, 5200 NE Elam Young Parkway, Hillsboro, OR 97124-6497. 
Intel Corporation assumes no responsibility for errors or omissions in 
this document or software. Nor does Intel make any commitment to update 
the information or software contained herein. Software product is 
supplied "as is" and may not be fully functional.

Other product and corporate names may be trademarks of other companies 
and are used only for explanation and to the owners' benefit, without 
intent to infringe.


RUNNING SETSPEED
----------------

SETSPEED must be run with one parameter as follows:

    SETSPEED <option>

<option> is one of the following:

    AUTO     - configures the driver to autonegotiate speed/duples
    10HALF   - configures the driver to force 10Mbps, half duplex
    10FULL   - configures the driver to force 10Mbps, full duplex
    100HALF  - configures the driver to force 100Mbps, half duplex
    100FULL  - configures the driver to force 100Mbps, full duplex

<option> may optionally be preceded by a '-' or '/' character.

NOTES:
------

* SETSPEED updates the system registry for every installed Intel adapter.

* If there are no supported Intel adapters or all drivers are already
  configured to use the <option> setting, no changes are made to the registry.

* The new speed/duplex setting will not take effect until the adapter driver
  is stopped and restarted. This may require the system to be rebooted
  depending on the version of Windows.

PROGRAM EXIT CODES:
-------------------

SETSPEED returns the following exit codes:

CODE NAME:               VALUE:
----------               ------      
SUCCESSFUL                  0
FAILURE                     1